SuperView 890s & DigitView 780s Freeview Satellite Receiver Set-Up

With Smart BLIND SCAN, installation for the SuperView 890 & DigitView 780s satellite receiver couldn’t be easier. Enjoy crystal clear Freeview TV in no time.  There is NO NEED to enter any parameter, the receiver will take care of itself.  Follow INSTRUCTION below !


Step 1
Press Menu button on your remote to go to the Main menu page, select Installation then Search Channels


Step 2
Find Optus D1 from Satellite Name list, press OK to select.   


Step 3
Press Blue button to go to Scan Mode. Change setting to as shown on picture, then press OK to start scanning.


Step 4
The receiver will scan and automatically find new channels.
Depending on location and signal strength, the search process will take around 4 to 10 minutes.  Once the process is done, save your setting.
Enjoy crystal clear Satellite TV.


Factory Default
If you have entered incorrect data, can not change them back, simply reset the receiver to Factory Default, then start the set up again from STEP1.

Sometimes if you do the initial set up when the weather is bad, signal is too weak to be detected. so maybe you can try again, when it is good weather.  Reset the box to Factory default again, then do a Blind Scan, see if you can get more channels.

Go to Menu then SETUP, select Set Default, then OK



Confirm Factory Default



Enter password "0000".  Receiver will be reset to its original status.



Advanced Settings
There is not need to change other settings normally, however, in some circumstances, it might be necessary to do so.  For example, if you are using a Sky dual LNB, you may need to change the 22K LNB to ON (you may need to change the "LNB Type" to "Normal Ku" before you can change this setting).  If you have another receiver connected to the same cable, and you are having problem, you may try toggling 12V power ON/OFF, etc. 


Contact our technical support if you still have problem.




See Installation Guide For Other Receiver